Note
The vehicle must be stationary to change the sensitivity. Keep the brake pedal pressed down throughout the procedure.
Put the vehicle in drive by selecting D with the right-hand steering wheel stalk.
Make sure that automatic lights mode 
is selected with the rotating ring on the left-hand steering wheel stalk.
is selected with the rotating ring on the left-hand steering wheel stalk.The following steps must be completed within 20 seconds:
Select auto high beam 
with the rotating ring on the left-hand steering wheel stalk.
with the rotating ring on the left-hand steering wheel stalk.The rotating ring springs back to automatic lights mode .
.Repeat the previous step 20 times.
Note
The sensitivity returns to the default setting when you start a new drive cycle.