High beam flash
Toggle between high and low beams
High beam flash
Pull the lever slightly toward the steering wheel. The high beams illuminate until the lever is released.
Continuous high beams
Continuous high beams are available if the ring is turned to 
1 or 
. Toggle to high beams by moving the lever forward. Return to low beams by moving the lever toward the steering wheel.
The 
symbol will illuminate in the instrument panel when the high beams are on.
Active high beams
The active high beam system uses a camera at the upper edge of the windshield to detect the headlights of oncoming vehicles or the taillights of a vehicle directly ahead. When this happens, the headlights will automatically switch from high beams to low beams.
When the camera no longer detects the headlights/taillights of other vehicles, your headlights will switch back to high beams after several seconds.
Operation
Activate/deactivate this function by turning the ring on the left-side steering wheel lever to .
If the ring is not in this position, toggling between high and low beams must be done manually.
If the ring is turned to another position while the high beams are on, the headlights will automatically switch to low beams.
A white symbol (
) in the instrument panel indicates that the function has been activated.
When the high beams are on, the symbol will change to blue.
Note
- Keep the windshield in front of the camera free of ice, snow, dirt, etc.
- Do not mount or in any way attach anything on the windshield that could obstruct the camera.
If a message is displayed in the instrument panel saying that active high beams are temporarily unavailable, switching between high and low beams will have to be done manually. However, the light switch can remain in the position. The same applies if a message saying that the windshield sensors are blocked and the 
symbol are displayed. The symbol will go out if this happens.
Automatic high beams may be temporarily unavailable (e.g., in heavy fog or rain). When the system becomes active again or if the sensors in the windshield are no longer obscured, the messages will disappear and the symbol will illuminate.
Warning
- Automatic high beams are a driving aid designed to help provide the best possible headlight illumination in good driving conditions.
- The driver is always responsible for manually toggling between high and low beams when this is required by traffic or weather conditions.
Important
In the following situations, it may be necessary to switch between high and low beams manually:
- In heavy fog or rain
- In blowing snow or slush
- In bright moonlight
- In freezing rain
- In areas with dim street lighting
- When oncoming vehicles have dim front lighting
- If there are pedestrians on or near the road
- If there are reflective objects, such as signs, near the road
- When oncoming vehicles' lights are obscured by e.g., fences, bushes, etc.
- When there are vehicles on connecting roads
- At the top of hills or in dips in the road
- In sharp curves
Auxiliary lights*
If the vehicle is equipped with auxiliary lights, the driver can use the center display to activate/deactivate them or decide if they will go on/off along with the high beams2.