Managing an SD memory card

Sensus Connected Touch allows the use of an SD memory card. This article describes how to manage an SD memory card.

Manage SD memory card

With Sensus Connected Touch it is possible to use an SD memory card. The card holder can be found in the unit located in the glove compartment.

Memory and save information

It is possible to manage an SD memory card with a memory of up to 32 GB. Note that if you have the iGo app, this is stored on the SD memory card.

Information can be both read and saved on an SD memory card. If you use a USB memory for Sensus Connected Touch, it is not possible to save information to it. The USB memory can only be used to read off information.

Remove the SD memory card

To remove an SD memory card, follow the instructions below:

Go to Settings in the app starter.
Select Advanced settings and then Storage.
Select Remove SD card and press OK.

Remove the write protection from the memory card

To remove the write protection from the SD memory card, follow the instructions below:

Remove the memory card by following the instructions under the heading 'Remove SD memory card'.
There is a small switch on the SD card. Adjust the switch to the write position and re-insert the card into Sensus Connected Touch.

This article is applicable to

  • Vehicle model/model year

  • S60 and V60 from model year 2011 to model year 2014.

  • XC60 from model year 2011 to model year 2014Model year 2011 only applies to vehicles manufactured after w.46..

  • V70, XC70 and S80 from model year 2012 to model year 2014

  • It is possible to install Sensus Connected Touch for model year 2014 onwards, however, not on vehicles with Sensus Connect.

  • The range of available models, systems and services may vary from market to market.

  • For vehicle models from and including model year 2020, see the online manual for that specific model.

Related documents