Fitting and removing the towing eye
Use the towing eye if the car shall tow another vehicle. The towing eye is screwed into a threaded socket behind a cover on the right-hand side of the rear bumper.
Note
Fitting the towing eye
Take out the towing eye from the foam block under the floor in the cargo area.
Remove the cover - press on the marking with a finger and, at the same time, fold out the opposite side/corner using a coin or similar.
Screw the towing eye right in until it stops. Screw the eye in firmly. For example, thread through the wheel bolt wrench* and use it as a lever.
Important
After use, unscrew the towing eye and return it to its place.
Finish by refitting the cover onto the bumper.