Emergency puncture repair - operation
Emergency puncture repair
Set up the warning triangle and activate the hazard warning lights if a tyre is being sealed in a trafficked location.
If the puncture was caused by a nail or similar, allow this to remain in the tyre. It helps to seal the hole.
Warning
Warning
Note
Warning
Remove the valve cover1
Take the torx wrench (which is fitted in the foam block behind the panel on the left-hand side of the cargo area).
Press the torx wrench into the hole.
Prize off the cover using the torx wrench (A).
Unscrew the valve cap and disconnect the hose from the compressor to the valve.
Note
Warning
Warning
Note
Important
Warning
Detach the hose from the tyre valve and fit the valve cap.
Press the cover2 back over the tyre valve with the hole against the wheel's hub. Two clicks confirm that the cover is fitted in place.