Using HomeLink®*

When HomeLink®1 is fully programmed, it can be used in place of the separate original remote controls.

Depress the programmed button. The garage door, gate, alarm system or similar is activated (may take a few seconds). If the button is depressed for more than 20 seconds then the reprogramming is started. The indicator lamp illuminates or flashes when the button has been depressed. Naturally the original remote controls can still be used in parallel with HomeLink® if required.

 Note

When the ignition has been switched off, HomeLink® works for at least 7 minutes.

 Note

HomeLink® cannot be used if the car is locked and the alarm is armed* from the outside.

 Warning

  • If HomeLink® is used to control a garage door or gate, ensure that nobody is near the door or gate while it is in motion.
  • Do not use HomeLink® for any garage door that does not have safety stop and safety reverse.
  1. * Option/accessory.
  2. 1 Applies to certain markets.